Joined
Last Online
Recent Posts
posted in 3D Printing read more

yup --got it right

posted in 3D Printing read more

@Morgul the example positions have a x5 instead of a z5 parameter on the tower position

First, one should home the delta printer, and carefully step down until the nozzle is ~1-2mm above buildplate – this will be your height found in config.txt as gamma_max

one should set gamma_max to about 5mm less than measured amount. this will insure that your trim setting will be a negative value, as the cost of a small amount of build height – the build height that you lose has an exceptionally small diameter due to the weird delta build area – so no big loss


Looks like your connection to festerND NaN was lost, please wait while we try to reconnect.